GB/T 35788-2017 PDF English
Search result: GB/T 35788-2017_English: PDF (GB/T35788-2017)
Standard ID | Contents [version] | USD | STEP2 | [PDF] delivered in | Name of Chinese Standard | Status |
GB/T 35788-2017 | English | 85 |
Add to Cart
|
0-9 seconds. Auto-delivery.
|
Security technical requirement for the electronic identification of motor vehicles
| Valid |
BUY with any currencies (Euro, JPY, GBP, KRW etc.): GB/T 35788-2017 Related standards: GB/T 35788-2017
PDF Preview: GB/T 35788-2017
GB/T 35788-2017: PDF in English (GBT 35788-2017) GB/T 35788-2017
GB
NATIONAL STANDARD OF THE
PEOPLE’S REPUBLIC OF CHINA
ICS 35.240.15
L 80
Security Technical Requirement for the
Electronic Identification of Motor Vehicles
ISSUED ON. DECEMBER 29, 2017
IMPLEMENTED ON. JULY 01, 2018
Issued by. General Administration of Quality Supervision, Inspection and
Quarantine;
Standardization Administration of PRC.
3. No action is required - Full-copy of this standard will be automatically &
immediately delivered to your EMAIL address in 0~60 minutes.
Table of Contents
Foreword ... 3
1 Scope .. 4
2 Normative References ... 4
3 Terms and Definitions ... 4
4 General Requirements ... 5
5 Life Cycle Security... 6
Bibliography ... 9
Foreword
This Standard was drafted as per the rules specified in GB/T 1.1-2009.
Please note that some contents of this document may involve the patents. The issuing
agency of this document shall not assume the responsibility to identify these patents.
This Standard was proposed and under the jurisdiction of Ministry of Public Security of
the People’s Republic of China.
Drafting organizations of this Standard. Traffic Management Research Institute of the
Ministry of Public Security, China Electronics Standardization Institute, Beijing
Zhongdian Huada Electronic Design Co., Ltd., Shanghai Quanray Electronics Co., Ltd.,
and National Quality Supervision and Testing Center for RFID Products.
Chief drafting staffs of this Standard. Cai Gang, Huang Jin, Fang Wansheng, Song
Jiwei, Liang Hao, Li Zhimin, Li Qiang, Lin Wanhua, Wu Weihong, and Li Kun.
Security Technical Requirement for the
Electronic Identification of Motor Vehicles
1 Scope
This Standard specifies the general security requirement and life cycle security for the
electronic identification of motor vehicles.
This Standard is applicable to the design, production, testing and application for the
electronic identification of motor vehicles.
2 Normative References
The following documents are essential to the application of this document. For the
dated documents, only the versions with the dates indicated are applicable to this
document; for the undated documents, only the latest version (including all the
amendments) are applicable to this document.
GB/T 35789.1-2017 General Specification for the Electronic Identification of Motor
Vehicles – Part 1. Automobile.
GM/T 0035.1-2014 Specifications of Cryptographic Application for RFID Systems
- Part 1. Cryptographic Protection Framework and Security Levels
GM/T 0035.5 Specifications of Cryptographic Application for RFID Systems - Part
5. Specification for Key Management
3 Terms and Definitions
The following terms and definitions and those ones stipulated in GB/T 35789.1-2017
are applicable to this document.
3.1 Identity authentication
The process that confirms the electronic identification of motor vehicles or reads and
writes the equipment claimed identity.
3.2 Ciphertext
b) The chip producer shall establish the chip identifier management mechanism,
through which to ensure the uniqueness of the chip identifier;
c) The initial key shall be written before the electronic identification of motor vehicles
leaves the factory; the transmission of the initial key shall establish the secure channel.
The generating and updating modes of the initial key shall be agreed between the
national registration authority of motor vehicles and the chip producer.
5.2 Initialization
The national registration authority of motor vehicles shall write the key to electronic
identification of motor vehicles; the read/write password in the registration information
area of the motor vehicles; the read/write initial password in user areas.
5.3 Personalization
The vehicle administration department of the public security organ shall write the
registration information of motor vehicles in the registration information area of the
electronic identification of the motor vehicles; and record the chip identifier,
identification serial number, etc. into the national public security traffic management
information system.
5.4 Use
5.4.1 Initial installation
After the completion of the personalization and initial installation for the electronic
identification of motor vehicles, the vehicle administration department of the public
security organ shall use read/write device to verify the registration information of motor
vehicles stored in the electronic identification of motor vehicles.
5.4.2 Replacement
After the electronic identification of motor vehicles is damaged or lost, it shall be
replaced. Finish the personalization and authentication of the electronic identification
of motor vehicles according to the requirements in 5.3 and 5.4; and mark the electronic
identification of original motor vehicle invalid in the national public security traffic
management information system.
5.4.3 Information reading
Use the application industry competent department authorized read/write device, after
through the two-way identity authentication, to read the information in the designated
user area.
5.4.4 Industry application information writing
The application industry competent department shall write the updated password and
...... Source: Above contents are excerpted from the PDF -- translated/reviewed by: www.chinesestandard.net / Wayne Zheng et al.
|